fipvlan - Fibre Channel over Ethernet VLAN Discovery
fipvlan [-c|–create] [-s|–start] interfaces
fipvlan -a|–auto [-c|–create] [-d|–debug] [-s|–start] [-l|–link-retry count]
The fipvlan command performs Fibre Channel over Ethernet (FCoE) Initialization Protocol (FIP) VLAN Discovery over Ethernet interfaces. fipvlan can be used as a diagnostic tool to determine which VLANs have FCoE services available on a network, prior to configuring VLAN interfaces and the Open-FCoE initiator. fipvlan can also be used to create VLAN interfaces as they are discovered, and to start the Open-FCoE initiator. The –create and –start options are primarily intended to be used as part of an Open-FCoE boot solution. FCoE instances started in this way cannot be destroyed or reset by fcoeadm.
fipvlan takes a list of network interface names to run the VLAN discovery protocol over, or the –auto option to use all available Ethernet interfaces.
fipvlan will enable any interface which is found disabled. If no response is received on that interface it will be shutdown again when fipvlan terminates.
Use all Ethernet interfaces currently available
Create network interfaces for discovered FCoE VLANs. If a VLAN device already exists for a discovered VLAN, a new VLAN device will not be created.
Enable debugging output
Start the Open-FCoE initiator on discovered FCoE VLANs
-f, –suffix suffix
Append the specified string suffix to VLAN interface names.
-l, –link-retry count
Retry check for link up to count times. The link state is checked every 500 ms. The default number of retries is 20.
Display a help message with basic usage instructions
Display the fipvlan version string
If a new VLAN device is created, it will have the name dev.vlan; where dev is the name of the Ethernet parent device and vlan is the discovered VLAN ID number. An optional suffix may be appended to this with the the -f command line option.
Display all discoverable VLANs with FCoE services
Discover FCoE VLANs on interface eth2, create VLAN devices and start the Open-FCoE initiator
fipvlan --create --start eth2
In this example if FCoE services were available on VLAN 101 of network interface eth2, then a VLAN interface eth2.101 would be created and used as the parent device for the initiator.
fipvlan is part of the fcoe-utils package, maintained through the Open-FCoE project. Resources for both developers and users can be found at the Open-FCoE website http://open-fcoe.org/
This document was created by man2html, using the manual pages.
Time: 18:47:31 GMT, January 24, 2013